Turbo Quattro

Hello,


Unit suddenly is dead and will stay rebooting IPL over and over


Unit shows this :

IPL: Audi 3G 9308 (SH7785) / QNX 6.3.0 [PL_qnx_ipl-3g_9308-sh7785_08253A, built 2008/06/18_15-16-25_UTC]
CPU: SH7785 (>= 5th cut, clk mode 20. 4xDDR), 792MHz
RAM: 0 MB (probed, DBCONF=ff0101)
FLASH: Spansion S29GL512N (32bit): 512 sectors x 256K
FPGA: PL_MMI3G_PLUS_FPGA_9411_D1_09422A
(0ms)
*** emergency FPGA loaded!
closepd-fashioned mark found on IFS @0x1c0000: .zero=0x3000°
=== UNEXPECTED EXCEPTION #E0 !!!
- PC = 800032c4
- PR = 80003866
- SR = 600001f0
- R0 = 800032b0 R1 = 8801011f R2 = 88010000 R3 = 88010100
- R4 = 8801011d R5 = e500e008 R6 = d008 R7 = 1c0100
- R8 = 10000000 R9 = e500f2d8 R10 = 1c0000 R11 = 80006084
- R12 = 800033dc R13 = 100000 R14 = e5011e18 R15 = e5011e18
================================================================


IPL: Audi 3G 9308 (SH7785) / QNX 6.3.0 [PL_qnx_ipl-3g_9308-sh7785_08253A, built 2008/06/18_15-16-25_UTC]
CPU: SH7785 (>= 5th cut, clk mode 20. 4xDDR), 792MHz
RAM: 0 MB (probed, DBCONF=ff0101)
FLASH: Spansion S29GL512N (32bit): 512 sectors x 256K
FPGA: PL_MMI3G_PLUS_FPGA_9411_D1_09422A
(0ms)
*** emergency FPGA loaded!
closepd-fashioned mark found on IFS @0x1c0000: .zero=0x3000°
=== UNEXPECTED EXCEPTION #E0 !!!
- PC = 800032c4
- PR = 80003866
- SR = 600001f0
- R0 = 800032b0 R1 = 8801011f R2 = 88010000 R3 = 88010100
- R4 = 8801011d R5 = e500e008 R6 = d008 R7 = 1c0100
- R8 = 10000000 R9 = e500f2d8 R10 = 1c0000 R11 = 80006084
- R12 = 800033dc R13 = 100000 R14 = e5011e18 R15 = e5011e18
================================================================


Any idea ?

BTW, 2x BGA have allready been renewed, same issue .

Thanks regards,

PL: Audi 3G 9308 (SH7785) / QNX 6.3.0 [PL_qnx_ipl-3g_9308-sh7785_08253A, built 2008/06/18_15-16-25_UTC]
CPU: SH7785 (>= 5th cut, clk mode 20. 4xDDR), 792MHz
RAM: 0 MB (probed, DBCONF=ff0101) <------------------------------------------------------------------------------------------
FLASH: Spansion S29GL512N (32bit): 512 sectors x 256K
FPGA: PL_MMI3G_PLUS_FPGA_9411_D1_09422A
(0ms)
*** emergency FPGA loaded!
closepd-fashioned mark found on IFS @0x1c0000: .zero=0x3000°
=== UNEXPECTED EXCEPTION #E0 !!!
- PC = 800032c4
- PR = 80003866
- SR = 600001f0
- R0 = 800032b0 R1 = 8801011f R2 = 88010000 R3 = 88010100
- R4 = 8801011d R5 = e500e008 R6 = d008 R7 = 1c0100
- R8 = 10000000 R9 = e500f2d8 R10 = 1c0000 R11 = 80006084
- R12 = 800033dc R13 = 100000 R14 = e5011e18 R15 = e5011e18
================================================== ==============

Also I think your unit was originally 3G but flashed with 3G+ firmware.

The RAM Memory is not available as simaservice1108 shows, thats the reason for rebooting IPL in loop. Known reaction in those cases.

Iy you correct renewed the the right DRAM chips, there cought be something with a defectiv MCU.

The Header talking about MMI3G - MU 9308 with copyright note from 2008 is normal for the first MU 9411 units...