MIB2 on desk

[SamBay]

Hi there,

I have an engineering background but I am kinda new for Automotive Multimedia systems. I need a help with setting up a MIB2 on desk and just reading the central unit status and communication. I got the following H/W:

MIB2 Harman (4G1 035 025 D)
Display (4G1919601R)
Display-MIB2 Cable (8V1971551C),

- What are H/W parts I am still missing?
- Do I need the MMI Touch Pad?
- What is the wiring should be done?
- What software can I use to monitor the communication of the MIB2 unit? How I connect the setup to a PC?
- Is there any thread in English I can read through?

Thanks in advance,
Sam

[congo]

Hi there,
- What software can I use to monitor the communication of the MIB2 unit? How I connect the setup to a PC?

Which communication? With what?

[SamBay]

Thank you so much for your replay Congo,

Can I over listen to the CAN commands between the display and the central unit through CAN to UART converter and check it out by PUTTY?

Or do I have to wire one of the two sets of (9+3) pins in the main board as in the attached image?

[SamBay]

Hi Congo,

Many Thanks for your replay. I need to read and log the CAN bus to check the messages between the central unit and the display. How Should be the wiring done as well.

[SamBay]

Done. Took 2 weeks to learn it from scratch.

Now: How to telnet into it?

I am going to buy 4G0035736 usb socket and DLink DUB-E100, However I am not sure about getting access.

[SamBay]

Just in order not to mislead anyone, the combination of the listed parts in the original post did not work.

[walawa75]

Hello Sambay,

There is noway and no help on this forum. I asked for telnet access for a long time but nobody reply. Or they can show the way to login if you give some dollars. Pathetic !! There is no help here.

[SamBay]

Yeah, The thing is I am willing to pay. However, how do I know it is not a scum.

[SamBay]

I don't care much about the current firmware on the unit - Which is already navigation plus. If there is a firmware for the Audi A6 MIB2 with know telnet password that will be enough.

[spyderboyant]

You can get the password hash from the image file.... You then need to crack it!