Hi,
i have a MMI 3G wich will not boot. since this is all new for me i do not understand what to do.
here is my log :
IPL: Audi 3G 9308 (SH7785) / QNX 6.3.0 [PL_qnx_ipl-3g_9308-sh7785_08253A, built 2008/06/18_15-16-25_UTC]
CPU: SH7785 (>= 5th cut, clk mode 20, 2xDDR), 792MHz
RAM: 512 MB (probed, DBCONF=e30002)
FLASH: Spansion S29GL512N (32bit): 512 sectors x 256K
FPGA: PL_MMI3G_FPGA_9308_D1_09324A
(0ms)
*** Old-fashioned mark found on IFS @0x1c0000: .zero=0x3000001d
*** Old-fashioned mark found on IFS @0x780000: .zero=0x10000000
starting image @780000 ...
Startup: PL_qnx_startup-sh7785_08362A, built 2008/09/02_07-53-12_UTC
RAM : 128 MB @0x08000000
RAM : 128 MB @0x40000000
NVRAM: 28 MB @0x5e400000
RAM : 228 MB @0x50000000
FLASH: 128 MB @0x00000000
System page at phys:0800a000 user:0800a000 kern:8800a000
Starting next program at v8804aa20
Welcome QNX6.3.2 (QNXLabel RL_qnx_os_632_PSP3_08041A)- Harman/Becker MMI3G Build 9307/08 D1-10291A
s: 0
v: 0
r: 0
m: 0
mkprocsymlinks 0.10, reading /mnt/ifs-root/etc/system/efs_symlinks.cfg
done
s: 0
v: 0
r: 0
m: 0
mkprocsymlinks 0.10, reading /mnt/ifs-root/etc/system/ifs-root_symlinks.cfg
done
starting server starter...
# multicored [000000000.727]:version 4.1.d, verbosity 1 (supported 4), scope 0x00000001, console: /dev/ser1 (fd=3), FILE_LOGGING, TESTCONTROL
multicored [000000000.760]:udp: broadcaster created
multicored [000000000.762]:attached to filesystem at /hbsystem/multicore, port 851
multicored [000000000.767]:MACHINE:SH(1), total MEM 507510784, 1: 271582976 SH7785 (SH4A) 792MHz, FPU
multicored [000000000.771]:sloop active
multicor
it just stops at multicor and then nothing happens. i already tried loading new software in emergency mode, all went fine without errors but still same problem.