Hello guys,
I have a MIB2 High unit for Audi. But due to wrong flash actions it is dead (wrong: flashit -a 54000 -d -v -f /net/mmx/fs/sda0/ifs-root.ifs)
Unit is now booting in Emergency App (red screen), but it not works. It can't read MIB Update from SD Card.
When I access by serial I see only following logs:
Normal mode:
IPL(0): A239 C0 (A239/C0) ver.13231A [built 2013-06-03 15:20:58 2821589+]
CPU: J5,PG3.0, 720/600/400 MHz (ARM/DSP/DDR)
RAM: 128 MB
Flash: 64 MB (GL-S type)
IOC boot mode len 16: N3B TB50(3AN~~~. ( 4e334220 54423530 2833414e 7e7e7e00)
[fastboot2: ARM=8020000/2]
=== loader args @838c0200 - 838c030c:
VERSION [ 0] I=0111131A L=''
LED [ 0] 481ac190 481ac194 00000019
DSP_PRIO [ 0] P=3
MEMORY [ 0] 08000001 04000000 80000000 08000000
DMA_PRIO [ 0] 080a0601 090e0602
COPY [ 0] S=8020008..804210f D=83000008..8302210f T=0
UCL [ 0] S=8042110..83b0d5b D=83022110..838c0003 T=0
WAIT [ 0]
DMA_PRIO [ 0] 080a0601 090e0602
STOP [ 0]
IPL mode:
IPL(0): A239 C0 (A239/C0) ver.13231A [built 2013-06-03 15:20:58 2821589+]
CPU: J5,PG3.0, 720/600/400 MHz (ARM/DSP/DDR)
RAM: 128 MB
Flash: 64 MB (GL-S type)
IOC boot mode len 16: N3B =C50(3AN~~~. ( 4e334220 3d433530 2833414e 7e7e7e00)
BREAK detected - press any key to stop the ipl within 5000ms! => BREAK accepted! 0
Entering CLI [?], type '?' for help
=>
when i use command flashit for flashing the Emergency App, i've got an error:
=> flashit -a 20000 -d -v -f /net/mmx/fs/sda0/em.ifs
--- writing 0xfffffff3 bytes from addr 0x20000 to offset 0xfffffff6 in NOR flash...
--- flash_write (dst=fffffff6, src=20000, len=fffffff3) ...
--- flash_erase (dst=fffffff6, len=fffffff3) ... [fffe0000..ffffffff]
=>
I can't Flash with commandflashit -a 540000 -d -v -f /net/mmx/fs/sda0/ifs-root.ifs
Same error.
who can help me?